CITADEL MESH
MIDI TOWER CASE
使用者手冊
配件包內容
面板拆卸
前/側面板拆卸
- Take off the front panel by pulling carefully from the bottom of the panel
- Remove the left side panel by pulling on the pull tab & swinging the door outwards, then lift off the hinges at the back of the case.
- Remove the right side pane by removing the two rear thrum screws and sliding the panel backwards
MOTHERBOARD INSTALLA
主板安裝
- Align your motherboard with the chassis to locate where the stand-offs should be installed Once done, remove the motherboard and fasten stand-offs accordingly
- Insert your motherboard I/O plate into the cutout at the rear of the case
- Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate
- Use the provided motherboard screws to attach your motherboard to the chassis
電源安裝
電源安裝
- Place PSU in the bottom rear of the case, within the PSU shroud
- 對齊孔並用螺絲固定
顯卡/PCI-E 卡安裝
顯卡/PCI-E 卡安裝
- 必要時卸下後 PCI-E 插槽蓋（取決於卡的插槽大小）
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied If mounting vertically, attach the vertical GPU mount to the PSU shroud, attach the Klink PCI-E Riser Cable (Sold separately). remove the rear PCI-E slot covers and put the card into place, mounting to the PCI-E Riser cable mount securely
- Remember to attach the other end of the PCI-E Riser cable to your motherboards PCI-E 16x slot
2.5″ SDD INSTALLATION (F)
2.5英寸SSD安裝（正面）
- Align your drive over the screw holes and secure with screws from the rear
2.5 英寸 SDD 安裝 (R)
2.5 英寸 SSD 安裝（背面）
Place your SSD on top of the HDD bracket and secure with screws
3.5英寸硬盤安裝
3.5英寸硬盤安裝
- Slide the drive into/onto the 3,5″ bay at the rear of the case
- Secure the drive on the both sides using the provided screws and hand tighten
頂部風扇安裝
頂部風扇安裝
- Remove the dust filter from the top of the case
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws
- Replace your dust filter once secured
前/後風扇安裝
前/後風扇安裝
- Align your fan to the screw holes on the chassis and secure with screws
水冷散熱器安裝
水冷散熱器安裝
- 將風扇固定在散熱器上，然後用外部螺釘將散熱器固定在機箱內
輸入輸出面板安裝
輸入輸出面板安裝
Carefully check the labelling of each connector from the 1/0 panel to identify their function
Cross reference with the motherboard manual to locate where each wire should be installed, then secure one at a time, Please ensure they are installed in the correct polarity to avoid non-function or damage
文件/資源
 |
KOLINK ANL-INT Citadel Mesh Midi Tower Case [pdf] 使用者手冊 ANL-INT, ANL-INT Citadel Mesh Midi Tower Case, Citadel Mesh Midi Tower Case, Mesh Midi Tower Case, Midi Tower Case, Tower Case |