FOTOSY BN1WC
FOTOSY Blood Pressure Monitor User Manual
Model: BN1WC
品牌:FOTOSY
一、簡介
Thank you for choosing the FOTOSY Blood Pressure Monitor. This automatic upper arm device is designed for convenient and accurate blood pressure measurement at home. Please read this manual thoroughly before use to ensure proper operation and to obtain the most reliable results. This monitor is intended for adult use only.
2. 包裝內容
打開包裝後,請檢查以下所有組件是否齊全:
- 1 x FOTOSY Blood Pressure Monitor (Main Unit)
- 1 x Adjustable Cuff (8.7"-16.5" / 22-42cm)
- 1 x 使用者手冊(本文檔)
- 1 x快速指南
- 1 個便攜式收納袋

Image: All components included in the FOTOSY Blood Pressure Monitor package.
3.產品特點
The FOTOSY Blood Pressure Monitor is equipped with several features designed for ease of use and accuracy:
- Dual User & Memory: Supports two users, each with 120 measurement data sets.
- 快速測量: One-button operation for fast readings.
- 可調式袖口: Fits arm sizes from 8.7 to 16.5 inches (22-42cm) for comfort and accuracy.
- 語音廣播: Provides real-time audio feedback during measurement. Volume is adjustable or can be turned off.
- Large Backlit LED Display: Clear and easy-to-read display for all measurement data.
- 電池供電: Operates on 3 AA batteries (not included) for portability.

圖片:詳細 view of the monitor's clear and easy-to-read LED display.

Image: Illustration highlighting the high accuracy of the monitor due to advanced internal chips.

圖片:結束view of the monitor's super performance features.
4. 設定
4.1 電池安裝
The monitor operates on 3 AA batteries. To install:
- 打開主機背面的電池倉蓋。
- 依照電池倉內的極性指示(+/-)裝入3顆AA電池。
- 關緊電池盒蓋。
Note: Batteries are not included and must be purchased separately. Remove batteries if the unit will not be used for an extended period.
4.2 連接袖口
將袖帶上的氣管連接到主機側面的氣嘴上。確保連接緊密,以防止測量過程中漏氣。

Image: The FOTOSY Blood Pressure Monitor with its cuff attached, ready for setup.
5. 操作說明
5.1 Proper Measurement Technique
為了獲得準確讀數,請按照以下步驟操作:
- 準備: Sit quietly for 5 minutes before measurement. Avoid talking or moving during the measurement.
- Wrap the Cuff: Wrap the cuff around your bare left upper arm. The bottom edge of the cuff should be about 2 to 3 cm (0.8-1.2 inches) above your elbow. Ensure the air tube runs down the center of your arm.
- 手臂位置: Rest your arm on a table or flat surface so that the cuff is at the same level as your heart.
- 開始測量: 按 開始/停止 button. The cuff will inflate, and the measurement will begin automatically. Remain still until the measurement is complete and the results are displayed.

Image: Visual guide for obtaining accurate blood pressure measurements.
5.2 雙用戶及記憶功能
The monitor supports two users (User 1 and User 2) and stores up to 120 readings for each. To switch between users:
- 短按 MEM button until the user ID (User 1 or User 2) starts flashing.
- 按 開始/停止 button to switch between User 1 and User 2.
- 按 MEM 再次按鈕確認您的選擇。
到 view past measurements, short press the MEM button repeatedly after selecting a user. The display will cycle through stored readings, showing date, time, systolic, diastolic, and pulse rate.

Image: Explanation of the dual user functionality and how to switch between user profiles.
5.3 語音播報
The monitor provides voice prompts for easier measurement. You can adjust the volume or turn off the voice function as needed. Refer to the quick guide or the full user manual for specific instructions on adjusting voice settings.

Image: The monitor's voice broadcast feature in action, providing audio guidance.
5.4 日期和時間設定
The date and time feature ensures accurate recording of each measurement, facilitating review and comparison of blood pressure changes over time. To set the date and time, typically you will press and hold the 放 button (if available) or a combination of MEM 和 開始/停止 buttons to enter setting mode. Follow the on-screen prompts to adjust the year, month, day, hour, and minute.
6、維護保養
- 打掃: 用柔軟的乾布擦拭顯示器和袖套。請勿使用研磨性清潔劑或將設備浸入水中。
- 貯存: 請將設備存放在提供的收納袋中,並置於陰涼乾燥處,避免陽光直射和極端溫度。
- 電池更換: 當顯示幕上出現低電量指示時,請更換全部 3 顆 AA 電池。
7。 故障排除
| 問題 | 可能的原因 | 解決方案 |
|---|---|---|
| 無顯示/裝置無法開機 | 電池沒電或安裝不正確。 | 檢查電池極性或更換新電池。 |
| 袖帶無法充氣或充氣量過少 | Cuff not connected properly; air leakage. | Ensure cuff tube is securely plugged into the monitor. Check cuff for damage. |
| 讀數不准確 | Improper cuff placement; movement during measurement; talking. | Refer to Section 5.1 for proper measurement technique. Ensure cuff is correctly sized and positioned. |
| 顯示屏上的錯誤信息 | Specific error (e.g., cuff too loose, irregular heartbeat detected). | Consult the quick guide or full user manual for specific error code meanings and solutions. Re-measure after a few minutes. |
如果問題仍然存在,請聯絡客戶支援。
8. 規格
| 規格 | 價值 |
|---|---|
| 型號名稱 | BN1WC |
| 品牌 | 福托西 |
| 電源 | 電池供電(3顆AA電池) |
| 用於 | 手臂 |
| 顯示類型 | 引領 |
| 袖口尺寸 | Adjustable 8.7"-16.5" (22-42cm) |
| 內存容量 | 2 users * 120 sets each |
| 包裝尺寸 | 6.38 x 4.76 x 4.72 英寸 |
| 物品重量 | 12.63 盎司 |
| 製造商 | 深圳市嘉瑪科技有限公司 |
9. 保固和支持
For warranty information and customer support, please refer to the contact details provided in the quick guide or on the product packaging. You may also visit the official FOTOSY store on Amazon for further assistance: FOTOSY Store.
10. 重要安全訊息
有關膳食補充劑的聲明未經 FDA 評估,且無意用於診斷、治療、治癒或預防任何疾病或健康狀況。
This device is intended for home use and should not replace professional medical advice or treatment. Always consult with a healthcare professional for diagnosis and treatment of any health condition.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.