VSYSTO 自行車後輪 View 相機使用說明書

Initial Setup and Unboxing

Unboxing the VSYSTO Bike-F3K

打開包裝後，您將發現以下組件：

• 帶括號的主機
• 有線控制器
• 前置和後置鏡頭
• 自拍相機
• 電源線
• GPS模組
• 輪胎壓力傳感器
• Various mounting brackets and screws
• USB測試線

組件結束view and Initial Test

Before proceeding with installation, connect all components to the host unit and perform a functional test. Use the provided USB test cable with a 5V 2A charger or power bank to power the unit. Verify that the display powers on and cameras show a live feed.

Figure 1: VSYSTO Bike-F3K main unit and accessories.

記憶卡安裝

Locate the waterproof plug for the TF card slot on the side of the host. Carefully insert the storage card, ensuring correct orientation. Securely close the waterproof plug and tighten the screw with the provided wrench to prevent water ingress.

Host Bracket Installation

The host unit can be mounted using either an L-shaped bracket or a handlebar clamp. For the L-shaped bracket, secure it to the host with screws. For the handlebar clamp, select the appropriate gasket size for your handlebar, secure the support with two screws, and then attach the host using the middle adapter and a large screw. Ensure all connections are tight to prevent movement during use.

Figure 2: Host unit mounted on a bicycle handlebar.

有線控制器安裝

The wired controller can be installed using Velcro straps or handlebar fixing accessories. For Velcro, fasten the straps to the controller and then to the handlebar. For fixed accessories, select the correct size for your handlebar, fix the screw, and tighten with a wrench. Ensure the controller is positioned for easy access during riding.

Camera Installation (Front, Rear, Selfie)

Install the front and rear cameras using their respective circular brackets. Secure the brackets with screws and tighten with a wrench. For the selfie camera, first install the shock-absorbing rubber ring, then the circular bracket, and secure it with a nut and wrench. Connect all camera cables to the host unit, ensuring the correct ports are used (labeled for front, rear, and selfie).

圖 3：結束view of the three camera units.

GPS模塊安裝

Find a suitable, clean location on your bicycle for the GPS module. Tear off the adhesive tape on the back of the GPS module and firmly paste it to fix it. Connect the GPS module cable to the host unit.

Tire Pressure Sensor Installation

After turning on the recorder, remove the valve cap from your tire. Screw the hex nut onto the valve nozzle first, then install the front and rear tire pressure sensors in sequence. After hand-tightening the sensor, use the provided wrench to reverse turn the hex nut to tighten the sensor, preventing it from falling off. Finally, check for air leakage with soapy water.

Figure 4: Tire pressure sensors and their display on the host unit.

電纜管理

Use the provided cable ties and cable buckles to secure all cables neatly along the bicycle frame. This prevents cables from becoming disorganized or interfering with riding. Ensure the blue charging port is covered with its waterproof cap to prevent water ingress.

Operating the VSYSTO Bike-F3K

有線控制器功能

The wired controller provides convenient access to various functions without needing to interact directly with the host screen.

• 向上按鈕： Short press to switch between different camera display modes (e.g., front, rear, selfie). Long press to switch to the selfie camera image.
• 向下按鈕： Short press to switch to the backup camera mode with parking lines. Long press to enter the auxiliary display interface.
• 確定按鈕： In recording mode, short press to enter emergency recording mode and capture a photo from the active cameras. Long press to enter the main menu page.
• 藍牙功能按鈕： Short press to enter the play music interface. Long press to switch to the dialed call interface, then to the received call interface, and finally to the missed call interface. Short press again to make or end a call. Long press to turn the recorder on/off.

Figure 5: Wired controller and its button functions.

輔助顯示模式

Long pressing the Down button on the wired controller enters the auxiliary display mode, providing various riding data:

• 當前車速
• Tire pressure and temperature (requires TPMS sensors)
• Altitude, longitude, latitude, atmospheric pressure (requires GPS)
• Short-term and long-term memory driving speed and mileage
• 時間和日期

Figure 6: Auxiliary display mode showing various riding data.

Bluetooth Phone Assistant Mode

Pair the recorder with your phone and Bluetooth headset to enable phone assistant mode. This allows you to play music and make/answer calls directly through the recorder using the wired controller. When a call comes in, the recorder displays the calling number and name (English name only). Press the remote to answer or decline calls. For music, press the remote to play/pause, adjust volume, and switch tracks.

Figure 7: Bluetooth Phone Assistant Mode in operation.

WiFi Function and Mobile App

The built-in WiFi module allows connection to the "WiFi Camera" mobile app (available on Google Play and App Store). Connect your phone to the recorder's WiFi network (starting with "MOTODV" or "VSYSTO"). Once connected, you can view real-time video, download, edit, and share recorded videos directly from your phone without removing the SD card. The app also allows viewing driving tracks via GPS data.

維護和保養

To ensure the longevity and optimal performance of your VSYSTO Bike-F3K, follow these maintenance guidelines:

• 打掃： Regularly wipe the host screen and camera lenses with a soft, dry cloth. Avoid abrasive cleaners or solvents.
• 防水完整性： Always ensure all waterproof plugs (especially for the TF card slot and charging port) are securely closed when not in use to prevent water damage.
• 電池保養： The built-in 4000 mAh rechargeable battery provides approximately 3 hours of continuous recording. Charge the device fully before long rides. Use a 5V 2A charger; higher voltages may damage the recorder.
• 貯存： 長時間不使用時，請將設備存放在陰涼乾燥處，避免陽光直射和極端溫度。
• 固件更新： Check the official VSYSTO web定期造訪網站或應用程式進行韌體更新，以確保最佳效能和存取新功能。

常見問題故障排除

產品規格

• 型號名稱： F3 (Bike-F3K)
• 產品尺寸： 0.98 x 4.52 x 2.95 英寸
• 物品重量： 3.3磅
• 影片捕捉解析度： 1080p 高清
• 展示： 4吋IPS屏
• 連接性： Wi-Fi、藍牙、GPS
• 特點： G-Sensor, Loop Recording, WDR, Selfie Mode, Auxiliary Display Mode, Overspeed Alarm, Parking Auxiliary Line, Temperature Sensor, Tire Pressure Monitoring Sensors
• 電池： Built-in 4000 mAh rechargeable battery (approx. 3 hours recording)
• 充電接口： Type-C (5V 2A input)
• 車輛服務類型： 自行車

保固和客戶支援

保固資訊

This VSYSTO product is covered by a manufacturer's warranty against defects in materials and workmanship. Please refer to the warranty card included in your product packaging for specific terms, conditions, and duration of the warranty.

客戶支援

For any technical assistance, troubleshooting, or warranty claims, please contact VSYSTO customer support through the following channels:

• 在線支持： Visit the official VSYSTO web本網站提供常見問題、支援文章和聯絡表單。
• 電子郵件支援： Refer to your warranty card or product packaging for the dedicated support email address.
• 行動應用程式： The "WiFi Camera" app may offer direct support options or links to customer service.

When contacting support, please have your product model number (F3 / Bike-F3K) and purchase details readily available to expedite the process.